The change in light intensity caused by the antigen antibody reaction is detected at 575 nm LED, as the change in transmitted light. D Dimer is the most common test performed in this category.
| Analyzer | Fully Automated Random Access Coagulation Analyzer |
| Throughput* | PT : 96 Tests/Hour |
| APTT : 64 Tests/Hour | |
| PT, APTT : 75 Tests/Hour | |
| Principle of Detection | Clotting : Scattered Light Detection Method |
| Chromogenic : Colorimetric Method | |
| Immunoturbidimetry : Latex Enhanced Turbidimetric Method | |
| Detection Channels | Seven numbers |
| Detection optics | LED Based with 640 nm, 405 nm, and 575 nm |
| Incubation Channels | Eight numbers |
| Clot detection | Clot detection Curve monitoring |
| Sample ID | 20 Characters custom, automatic generation possible |
| Units of measurement | seconds, dOD, % Ratio, INR, Dfbg |
| Sample Types | STAT, patient sample, control |
| Minimal Sample volumes | PT, APTT, TT: 50 μl; Fbg, ATIII: 10 μl; Factor Assays: 5 μl, Erba D-Dimer R : 15 μl |
| No. Of Sample Racks | Three |
| Total Number of Samples | 27 numbers, continuous loading |
| Sample Bar code Reader | Yes |
| Tests per group | Ten tests |
| Reagents on-board | 20 reagents cooled at 13-15 C. 3 reagent locations for Clean, Diluent and Buffer |
| Dispensing | Pre-heating probe, with level sensing and vertical obstruction detection |
| Calibration Mode | Manual and Automatic |
| Calibration | 6 Calibration points |
| Reagent Management | Lot Number, Expiry, Reagent Name and Type, Volume monitoring |
| Analysis modes | Re-dilution, Re-testing, Repeat analysis |
| Incubation | Detector : 37°C + 1°C |
| Sample Incubator Section : 37°C + 1°C | |
| Reagent Pipette : 37°C + 1°C | |
| Quality Control algorithm | L-J and Multirules, 12 levels |
| Display | 8" LCD Graphical touch screen display |
| Printer | Built-in printer |
| Operating System | Windows XP |
| Database | 100,000 test results, 10,000 clot curves |
| Interface | No Interference for Haemolysed, Icteric, Lipemic (HIL) samples |
| Factor Assay | Generation of Standard curve |
| Mains input | AC 100V/220V, 50Hz or 60Hz |
| Input power | 400VA |
| Operational environment | 10 C ~ 30 C, relative humidity ≤ 70% |
| Storage environment | -20 C ~ 55 C, relative humidity ≤ 85% |
| Dimension L x W x H | 660 x 580 x 510 |
| Weight | 53 kg |
